Chapter 20:Documenting the ATM Network Topology


Презентация изнутри:

Слайд 0

Chapter 20: Documenting the ATM Network Topology 20-1 Copyright © 1998, Cisco Systems, Inc.


Слайд 1

Verify the ATM Switch Processor ILMI parameters Verify the Catalyst® ILMI parameters Enable VTP on the LANE module Discover the ATM network fabric Upon completion of this chapter, you will be able to: Objectives


Слайд 2

Start AtmDirector™ Display the ATM network fabric Interpret the ATM topology map Display device and link information Modify the ATM topology display Objectives (cont.)


Слайд 3

Uses SNMP packet types over AAL5 Adjacent nodes exchange autodiscovery information Automatically configures end-system addresses AtmDirector and ILMI


Слайд 4

Physical interface MIB Per-VCC statistics MIB ATM-layer interface MIB ATM-layer statistics Virtual channel MIB AToM MIB


Слайд 5

Required on at least one ASP interface Used for network management Verifying Parameters on the LS1010 ASP


Слайд 6

Configuring ILMI Parameters on the LS1010 ASP Enable ILMI Show ILMI status Show ILMI configuration


Слайд 7

Configuring ILMI on the Catalyst ATM Module ILMI is enabled by default Well known VPI/VCIs are used for ILMI and signaling ILMI keepalive timers must be enabled at both ends of a link or not used at all


Слайд 8

Disabled by default Must be done before discovery Forces the default VLAN to be added Default VLAN needed for management Enabling VTP on the Catalyst ATM Module


Слайд 9

Configuring the LECS and LES/BUS


Слайд 10

Configuring a Backup LECS


Слайд 11

Discovering the ATM Network


Слайд 12

Displaying the ATM Network Fabric


Слайд 13

Interpreting the ATM Topology Map


Слайд 14

Displaying Details in the ATM Topology Map


Слайд 15

Modifying the Topology Map Preferences


Слайд 16

AtmDirector automatically merges and separates fabric maps Merges concatenate names Separation appends -1 and -2 to original names Original map must be closed to delete it Merging and Separating ATM Fabrics


Слайд 17

Summary Verify the ATM Switch Processor ILMI parameters Verify the Catalyst ILMI parameters Enable VTP on the LANE module Discover the ATM network fabric Start AtmDirector


Слайд 18

Summary (cont.) Display the ATM network fabric Interpret the ATM topology map Display device and link information Modify the ATM topology display


Слайд 19

Lab Diagram ATM Switches Catalyst Switches Fiber Catalyst Switches


×

HTML:





Ссылка: